You should see (under the "Bus Name") the words "Stereo In" and underneath this "left" and "right" (see image below). You can do this by going to devices/VST connections and clicking on the "Imputs" tab in this menu. Make sure that you have activated the recording drivers in your Cubase project. Make sure that you are recording the vocals on an audio track (not midi or vst instrument track!) (You'll need to refer to your soundcard manual for this). I've tried the above options and Cubase is still not recording any vocals!Ĭheck that the cables are correctly routed into the soundcard. Then OK and close this window, and select the stereo out options where you saw the "no buss" message in the inspector. In the dialogue box, Select stereo, and 1 Count. If it says "no buss", then you will need to activate a buss by opening the Vst Connections menu (F4 or Devices/Vst Connections):-Ĭlick on the "Outputs" tab, and then click on "Add Bus". There should be an option something like "audio out" and the name of your sound card - make sure that this is selected. You can do this by going to inspector and looking underneath the volume and pan controls. If there is still no volume, then check that you have an audio driver associated with this track. Try switching it with a different cable if you have a spare. If you don't, make sure you havn't overlooked obvious things - are the speakers on? If you're using a physical mixing desk, is it switched on and are the faders up? Check the cabling out of the sound card to the speakers/desk. Make sure that it is not a general problem with Cubase by playing other tracks (midi or vst instrument tracks) and see if you can hear anything. Check the channel is not muted, and check in the mixer (tools/mixer) that the volume is up on the vocal channel, and the master channel is also up. If you do, this is a good sign - you are recording the vocals, it's just for some reason you can't hear it. If you've successfully recorded some vocals, you should see a "wave form" in the box (not just blank or a straight line), similar to the orange box in this example (these screen shots are taken from Cubase 5):. When you've finished recording, there should be a rectangular box in the track. When you hit record on the transport menu, is the red record enable button active? (see green area circled below). Here's a list of things to help diagnose the problem:-ġ. There are a number of reasons why you may not be getting Cubase to record your vocal. (there's no sound when I playback the recording) the quality of the vocal - it doesn't sound very professional there's "crackles" and "popping" sounds on the recordingĮ. I can't get it to record anything! (there's no sound when I playback the recording)ĭ. I've broken this down into four common problems:-Ī. Recording vocals in Cubase is a big area - there's a number of issues involved here. I tend to blend a little of all three to get the vocals to sit just right.Īdding reverb will almost always make the vocals feel like they are being pushed back in the mix, but you can add a little predelay (50-100 ms) to make the vocalist feel like they are close to the listener, but still in a large room.Some common problems and suggested solutions My favorites are plate (tight, high frequencies, linear decay), hall (usually dull sounding, 3D, lush), and room (tight, early reflections, width). Without getting too much into the nuances of reverb, there are a few different types that have different sounds. If you to gel your vocals with other instruments, this is my favorite way to do it. Instead, just using a delay might be a better option. Depending on what you are trying to achieve, you may not need to add any reverb at all (very dry, clear vocal sound).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |